-------- The previous posted details of issue ---------------------------------------
Playing around with a Basic program that loads a data file and outputs information (data) to screen. I went to press CTRL+C to exit the current looping, but pressed CTRL+V.... and here it's a bit fuzzy, but then I think if you press CTRL+C to exit, it doesn't - and then it starts printing unusual "op codes" and data to screen with "?Syntax Error" then another, and another (many more than shows on my screen shot). I can't seem to exit this loop... but, my program loops through to the end I assume (which is how it's ending?).
After the errors finish, I think - Ok, I'll rerun the program, but it failed due to a 'new' Line 0 error. When I list the program - there are now lines 0,10,20,30,40,50,60,70,80,90 inserted which are ML op codes?
See below image - which shows the tail end of the output (to when it stopped). I then printed the Help command for the version info. I had earlier "reset" the emulator and loaded in my program before I noticed this issue.
The only link to the issue is perhaps "large PC copy buffer" issue?... as I have replicated the same result several times (3-4), but couldn't work out how to do so knowingly? Then, I just replicated it with a different large data source (in copy buffer of PC) and noticed, it isn't ML op code specific, but what is in memory of Copy. NOTE: I didn't realise I must have had a large amount of copied ML op codes that I was working on ealier still in PC copy buffer memory? This latest version of the error, which was just spewing my "data" numbers to screen for each Syntax Error line, did not add in to the program code lines afterwards. (So the ML lines may have been unique to the event for them to add in new lines of basic?).
- CTRLVSyntaxErr.jpg (64.25 KiB) Viewed 4011 times